Pass NS0-014 Exam - Real Test Engine PDF with 112 Questions
Get New NS0-014 Certification Practice Test Questions Exam Dumps
NEW QUESTION # 17
In a MetroCluster environment, which two steps are required to configure FC switches? (Select two)
- A. Configure IPsec for secure communication
- B. Set up inter-switch links (ISLs) between the FC switches
- C. Configure VSANs for all switches
- D. Enable NPIV (N-Port ID Virtualization)
Answer: B,D
NEW QUESTION # 18
Which ONTAP feature allows MetroCluster administrators to non-disruptively upgrade their environment to a new ONTAP version?
- A. SVM DR
- B. SnapVault
- C. Automated Non-Disruptive Upgrade (NDU)
- D. SnapMirror
Answer: C
NEW QUESTION # 19
What does the ONTAP Mediator specifically manage in an IP MetroCluster configuration?
- A. Load balancing
- B. Cluster failover events
- C. Data synchronization
- D. Data deduplication
Answer: B
NEW QUESTION # 20
What are two requirements when transitioning from an FC MetroCluster to an IP MetroCluster configuration? (Select two)
- A. Removal of all FC switches
- B. Upgrade to ONTAP 9
- C. Install ATTO FibreBridges
- D. Implementation of IP switches
Answer: B,D
NEW QUESTION # 21
What are two methods used to test failover in a MetroCluster configuration? (Choose two)
- A. Disconnecting the Mediator
- B. Powering off a storage node
- C. Shutting down an FC switch
- D. Running the metrocluster switchover command
Answer: B,D
NEW QUESTION # 22
What is the recommended maximum latency for the round-trip between two MetroCluster sites?
- A. 5 ms
- B. 15 ms
- C. 1 ms
- D. 10 ms
Answer: D
NEW QUESTION # 23
What are two key considerations when deploying a MetroCluster solution? (Select two)
- A. Type of storage media used
- B. Whether deduplication is enabled
- C. Bandwidth availability for inter-site communication
- D. Distance between MetroCluster sites
Answer: C,D
NEW QUESTION # 24
Which component is responsible for managing site failover in an IP-based MetroCluster?
- A. SyncMirror
- B. SnapMirror
- C. ATTO FibreBridge
- D. ONTAP Mediator
Answer: D
NEW QUESTION # 25
Which of the following are critical factors in planning a MetroCluster deployment? (Select two)
- A. Office furniture layout
- B. Rack size
- C. WAN bandwidth
- D. Network latency between sites
Answer: C,D
NEW QUESTION # 26
What is the recommended minimum distance between MetroCluster sites to avoid potential issues with data replication latency?
- A. 200 km
- B. 100 km
- C. 50 km
- D. 10 km
Answer: C
NEW QUESTION # 27
What should you do before adding new nodes to an existing MetroCluster configuration?
- A. Install a new mediator
- B. Verify that the new nodes are compatible using IMT
- C. Run diagnostics on all existing nodes
- D. Disable SyncMirror
Answer: B
NEW QUESTION # 28
What are two benefits of performing a Non-Disruptive Upgrade (NDU) in a MetroCluster environment? (Select two)
- A. Reduced risk of data loss
- B. Higher system performance during the upgrade
- C. Immediate application of all new features
- D. Avoidance of service outages
Answer: A,D
NEW QUESTION # 29
During MetroCluster assessment, which network topology is most commonly used for communication between sites?
- A. Mesh
- B. Point-to-point
- C. Hub-and-spoke
- D. Star
Answer: B
NEW QUESTION # 30
What is the primary benefit of upgrading the Mediator in a MetroCluster configuration?
- A. Simplified configuration management
- B. Higher storage capacity
- C. Improved failover response time and reliability
- D. Faster replication speed
Answer: C
NEW QUESTION # 31
Which MetroCluster component requires reconfiguration when upgrading from a 2-node to a 4- node configuration?
- A. SyncMirror
- B. ATTO FibreBridge
- C. FC switches
- D. Mediator
Answer: C
NEW QUESTION # 32
An administrator is asked to do a nondisruptive system refresh, replacing all their NetApp FAS8200 controllers and disk shelves with newer NetApp AFF A900 controllers and disk shelves.
Which two actions should the administrator take to migrate the data onto the new nodes before retiring the old controllers? (Choose two.)
- A. Create a second DR group.
- B. Perform an aggregate relocate.
- C. Perform a volume move.
- D. Create a network failover group.
Answer: A,C
NEW QUESTION # 33
......
NS0-014 Exam Dumps - PDF Questions and Testing Engine: https://guidetorrent.dumpstorrent.com/NS0-014-exam-prep.html